Add a touch of leather to your gift with this Kraft Board and Leather Gift Tag with fun geometric engraved shapes on them.
When people think Cricut they think vinyl. You can definitely cut vinyl, and do it flawlessly, but there is so much more. With the standard blade you can use it for iron on, paper, cardstock, craft board, foam, and felt. You can also get the rotary blade and cut fabric! I have put together a project cutting metallic leather and then Kraft Board. I then used a technique to engrave the Kraft Board!
What You Need For Your Leather and Kraft Board Gift Tags
- Metallic Leather
- Kraft Board
- Scoring Wheel
- Glue Tape
- Cricut Maker
Shop this Project!
Cricut® MakerBuy NowKraftboardBuy NowCricut® Faux Leather –Buy NowCricut® Scoring WheelBuy Now
Use this project here to cut your leather. Then engrave your Kraft Board as the instructions show. You will install your scoring wheel and it will do the engraving for you. After that you will reinstall your deep cut blade to finish the cut. After that you should have six pieces that look like this.
Once your pieces are cut, you will attach them to your metallic leather. I like using this glue tape for crafts like this.
Then you are all finished! This is a super simple little project but I think it shows off just a glimpse of what your Maker can do with the touch of a button. (Ok you have to push the button three times, but that’s not bad at all!)
Save the pin below if you want to reference this fun quick project again!
